Z Drives
Materials
| Hardware (for 1 of 4 Z-Drives) | Qty |
|---|---|
| Stepper w/ Gearbox - LDO-17Hs15-1584S-MG5 | 1 |
| GT2 20T Timing Pulley - 9mm Belt | 1 |
| Shaft Coupler | 1 |
| M5x60 D-Shaft | 1 |
| Bearing - 625 | 2 |
| M3x5.7 Brass Insert | 5 |
| M5x10x1 Washer | 4 |
| M5x16 BHCS | 5 |
| M3x40 SHCS | 4 |
| M3x10 SHCS | 3 |
| M5 Roll-In Nut | 5 |
| Printed Parts | Qty |
|---|---|
| Z Drive Housing A | 2 |
| Z Drive Housing B | 2 |
| Z Drive Housing Cap A | 2 |
| Z Drive Housing Cap B | 2 |
| Z Motor Mount A | 2 |
| Z Motor Mount B | 2 |
| Z Drive Roll-In Nut Alignment Tool | 1 |
Animated Assembly
Assembly Notes
- 0:41 Should say “Shaft Coupler” instead of “Shaft Collar”. Tighten one set screw against the flat face of the D-shaft first, then tighten the other set screw.