Bed Wheels & E-Chain Mount
Materials
| Hardware | Qty |
|---|---|
| Extrusion - 2020-202 | 1 |
| M6x250 Shaft | 1 |
| Bearing - 625 | 2 |
| M5x20 BHCS | 6 |
| M3x25 SHCS | 2 |
| M3x10 SHCS | 7 |
| M5 Roll-In Nut | 4 |
| M3 Roll-In Nut | 9 |
| Printed Parts | Qty |
|---|---|
| Bed E-Chain Mount - Clip | 1 |
| Bed E-Chain Mount - Frame | 1 |
| Bed Frame - Wing Pivot Axle | 1 |
| Bed Frame - Wing Pivot Axle Endcap | 2 |
| Bed Wheel Wing | 2 |
| Bed Wheel | 2 |
Animated Assembly
Assembly Notes
- 7:44 The M5 BCHS should bottom out before clamping the bearing. Glue can be used to secure the screw in the plastic. The wheel should spin freely.
- 8:01 This is to show that the end of the extrusion should butt up against the inside face of the pocket in the Wheel Wing.
- 8:58 These M3x25 SHCS should bottom out in the extrusions and create two posts. They help keep the Bed Wheels from twisting in Rz. Use threadlocker on the ends of them and screw them tight against the extrusions.
- 9:04 A bit of rubbing is OK, the whole Bed Wheel assembly needs to be able to pivot under (essentially) the weight of the bed.
- 9:16 Optional, but recommended.